How To Install A Dishwasher The Definitive Guide

Having a dishwasher will make your life so much easier since you won’t have to wash your dishes by hand. However, it can be difficult to install a new dishwasher. Many people will buy a dishwasher and hire a professional to install the new appliance. Although this is one option, you can save money by doing it yourself. With the right know-how, you can possibly install your new dishwasher within four hours. A&E NYC Plumbing When you’re ready to begin, follow the guide below to get your new dishwasher installed properly.

Get Rid Of The Old Dishwasher

If you have an old dishwasher, you’ll have to get rid of it before installing the new one. Truthfully, this will be the easiest step of the process. The only hard thing will be finding a suitable disposal method. Remember that your old dishwasher is connected to a water and electricity supply. Therefore, you’ll have to turn off both to avoid getting electrocuted and creating a mess. Turn off the electricity at the circuit breaker. There should be a water shut-off valve near the dishwasher. Turn it off. Once you’ve done this, you’ll need to remove the dishwasher’s front access panel using a screwdriver. Then, you can disconnect the wiring and the old water supply. Use a rag or bowl to catch the remaining water. The dishwasher is likely anchored to the nearby cabinets and the countertop. Get rid of these screws so you can remove the dishwasher from the designated slot. Before installing the new model, it is wise to get rid of the old one. You don’t want to have to do this later.

Prepare The New Dishwasher

Get assistance from a friend or two so you can bring in the new dishwasher without dropping it or damaging your home. Unpack the dishwasher and look at the instruction manual. Although the installation process is similar, there might be a difference or two between each unique model. Keep a piece of cardboard so you can protect your floor when sliding the new dishwasher into the hole. Lay the dishwasher on its side so you can access the wires easily. Unscrew the screws holding the front access door. The installation kit should come with a 90-degree elbow. Attach it now. You’ve likely received a new water supply valve and hose. The old supply line should be removed. Install the new one so it can be connected easily. Route it through the cabinet. You may need to use tape to hold the hose in place. Remove the old drain line and route the new one through the adjacent cabinet. The drain house should have a slope to prevent backwash.

Connecting The Lines

Once you’ve finished the steps above, it is time to push the dishwasher into place. You’re going to have limited space so it’ll be hard to connect the lines. Still, you’ll need to connect the water line, drain line, and electric cables. Remember to leave the electricity and water off until these things are connected. The water supply should be attached to the elbow. Check each connection carefully to ensure that you’re not going to encounter any leaks. Once you’ve finished with the water supply, you’ll need to connect the drain and electrical wires. You’ll also need to level the unit using a bubble level. You can raise one side or the other by using the legs at the bottom of the dishwasher. After you’ve double-checked everything and made sure that the dishwasher is level, you can install the front access panel. Be sure that the front of the dishwasher is even with the cabinets. Working with electricity can be risky unless you know exactly what you’re doing. Therefore, it might be a good idea to hire a professional. Turn on the electricity and water supply. Check the dishwasher and make sure everything is working properly. If you need assistance or if something is wrong, hire a professional to diagnose and fix the problem.